GreenWorks 2601002 Manual Del Propietário página 21

TROUBLESHOOTinG
PROBLEm
The snow shovel
does not start.
The motor is on, but The belt is damaged.
the rotor does not
turn.
The snow shovel
leaves a thin layer
POSSIBLE cAUSE
The snow shovel is
unplugged.
The lock-out button or trigger
switch were not used properly.
The scraper is worn.
SOLUTION
Verify that the snow shovel is plugged
into an electrical outlet.
Press and hold the lock-out button, and
then lift and hold the trigger switch (see
the section entitled STARTinG THE
SnOW SHOVEL on page 13).
Replace the belt (see the section entitled
INSPECTING/REPLACING THE DRIVE
BELT on page 15).
Replace the scraper (see the section
entitled REPLACinG THE SCRAPER on
page 17).
21