Sunny SMART SF-RBE4886 Manual Del Usuario página 15

We value your experience using Sunny Health and Fitness products. For assistance with parts or
troubleshooting, please contact us at support@sunnyhealthfitness.com or 1-877-90SUNNY
(877-907-8669).
STEP 3:
Remove 2 Hex Screws (No. 26), 2 Spring
Washers (No. 37), 2 Flat Washers (No. 33)
and 2 Wave Washers (No. 85) from the Long
Axle (No. 40) with 2 Spanners (No. 129).
Insert the Long Axle (No. 40) into the
Handlebar Post (No. 4), then put on 2 Wave
Washers (No. 85), that were just removed, on
both sides of the Long Axle (No. 40). Attach
the Left & Right Swing Bars (No. 19L & No.
19R) on both sides of the Long Axle (No. 40)
using 2 Flat Washers (No. 33), 2 Spring
Washers (No. 37) and 2 Hex Screws (No. 26),
that were just removed. Pre-secure with 2
Spanners (No. 129).
NOTE: If there is difficulty inserting the Long
Axle (No. 40) into the Handlebar Post (No. 4)
by hand, consider using a hammer to gently
tap the Long Axle (No. 40) into the Handlebar
Post (No. 4).
NOTE: Do not completely tighten the Hex
Screws (No. 26) yet.
STEP 4:
Attach Left & Right Swing Bars (No. 19L &
No. 19R) to Left & Right Pedal Support
Tubes (No. 2L & No. 2R) with 2 Spacers (No.
32) and 2 Nylon Nuts (No. 28) using Open
End Wrench (No. 130).
NOTE: Do not completely tighten the Nylon
Nuts (No. 28) yet.
14