Ideal Test Pro 360 Serie Manual Del Usuario página 13

General Specifications:
Indicators: Continuity: (30Ω) indicated by a continuous
"beep" within 100 msec. Low Battery indicator displayed in the
LCD when battery is below operating range. Overrange: "OL"
displayed.
Environmental: Operating temperature 32°F to 122°F, storage
0°F to 140°F with batteries removed, RH<70%.
LCD: 3.5 digits.
Size: 4.0"W x 7.5"H x 2.5"D
Weight: 18 oz. including battery.
Battery life: >200 hours typical (9V NEDA 1604 type, JIS006P,
IEC6F22 battery).
Accessories: Comes with a pair of test leads ground lead with
clip, operator' s manual, and battery.
Overload Protection: 600V for DCV, ACV, and phase indica-
tion. 500VAC/500VDC for capacitance, ohms, frequency and
diode test. Current protected by 2A/600V (6.35mm x 25.4mm)
fuse model LA-3893 and 0.1A/250V (5mm x 20mm) fuse model
LA-3898.
Auto Power Off: 25 minutes
User Maintenance
Regular operator maintenance of the multimeter consists of
cleaning case and window, and battery replacement. All other
repairs must be performed by a factory service center or other
qualified instrument service personnel.
Cleaning Case and window
Periodically wipe the case with a damp cloth and detergent,
allow to dry completely before using; do not use abrasives or
solvents.
Fuse Replacement
1. Disconnect the test leads and turn the meter off. Remove the
test leads from the front terminals.
2. Position the meter face down. Remove the screws from the
case back. Lift the end of the case back until it gently unsnaps.
3. Remove the fuse by gently prying one end of the fuse loose and
sliding the fuse out of the bracket.
4. Verify continuity across the fuse.
5. If the fuse is blown, install a new fuse of the same size and rating.
6. Replace the case top. Reinstall screws.
Page 13