Sennheiser HDV 820 Guida Rapida página 13

Putting the HDV 820 into
operation
Setting up the headphone amplifier
CAUTION
Risk of staining of furniture surfaces!
Varnish or furniture polish may degrade the feet of the product,
which could stain your furniture.
▷
Do not place the product on delicate surfaces; if necessary, use a
non-slip pad under the product.
▷
Place the headphone amplifier on a flat, horizontal and low-vibra-
tion surface.
▷
Ensure circulating ventilation. The product generates heat which
is dissipated through the housing.
Connecting the headphone amplifier to
audio sources
You can connect several audio sources to the headphone amplifier
and switch between these connected sources using the
tion
rotary switch.
▷
Switch your audio sources off before connecting the headphone
amplifier.
▷
Select a suitable high-quality connection cable for your audio
source. For an optimal listening experience, we recommend using
cables with a length of 3 m.
▷
To connect the headphone amplifier to your audio source, refer to
the connection diagram suitable for your audio source (see the
following chapters):
Connection possibility
of the audio source (OUT)
A
USB
B
Optical (OPT)
Coaxial
C
(COAX)
D
RCA (UNBAL)
E
XLR-3 (BAL)
Putting the HDV 820 into operation
Connection cable
USB 2.0 certified cable
with Type A and Type B
connector
Optical cable
Coaxial cable (75 Ω)
Stereo audio cable
with 2 RCA connectors
at each end
2 balanced
XLR-3 cables
Input selec-
Page
10
10
10
11
12
HDV 820 | 9