Sennheiser HDV 820 Guida Rapida página 25

Selecting the audio source
WARNING
Danger of hearing damage!
Before switching to a different audio source, first set the volume on
the headphone amplifier to a low level. Different audio sources and
different listening material (e.g. different pieces of music on different
CDs/sound carriers) can have widely varying signal levels. In the
case where you switch to a higher level audio source from a lower
one without first reducing the volume level this can lead to high vol-
ume levels in the headphones and could damage your hearing.
▷
Set the volume on the headphone amplifier to a low level (see
page 22) before switching to a different audio source.
▷
Use the Input selection
audio source.
Input selection
The
audio source.
o
Selected audio source on the headphone
Selection
amplifier
USB (digital), the
USB
also light up white (see page 12)
OPT Optical (digital)
COAX Coaxial (digital)
UNBAL RCA (analog)
BAL XLR-3 (analog)
rotary switch to select your connected
LED lights up white, indicating the selected
DSD reproduction
Using the HDV 820
LED might
HDV 820 | 21