EMAK SATR 15,5 H Manual De Usuario página 33

Four replacement shear pins for the cutting blades are packaged with the grass
catcher.
Store these pins for later use.
 GRASS CATCHER - MAIN PARTS (TERMINOLOGY)
(1) - Lid
(2) - Lifting lever
(3) - Lower tube
(4) - Left and right corner brace
(5) - Lower brace (in the 300l version only 1x)
(6) - Side struts
(9) - Handle
(10) - Front tube
(11) - Sack (mesh)
(13) - Control grass tipping bracket
 INSTALLING THE GRASS CATCHER
Screw the grass catcher hinges (1) and hinges (2) on to the rear plate.

- On some machines, the hinges (1) are already pre-mounted on the rear plate.
- Hinge (2) is attached only if a trailer is used.
Into the upper holes in the brace that fastens the front tube above, insert M5x16 bolts,

secure them with washers and nuts, and lightly tighten them. Also tighten the lower,
pre-inserted bolts.
Attach two corner braces to the frame using M5x25 bolts and nuts. Make sure not to get

the left brace and right brace switched. The left brace is clearly marked "L".
Screw on the side struts of the grass catcher. The struts are attached to the inner side of

the grass catcher using M5x16 bolts and nuts.
For the catcher on the 360-litre model, ignore this point — the side braces are premounted.
Screw the bottom tube to the frame. For easier assembly, we recommend that the grass

catcher is turned upside down. From the underside attach the bottom tube to the corner
braces using M5x25 bolts and to the front frame using M5x30 bolts. After attaching turn
the grass catcher back over.
Slide the grass catcher sack on to the frame. Pull the rubber sides of the sack over the

tubes.
From the underside of the grass catcher bolt in the lower braces (

Attach them using M5x30 and M5x35 bolts to the lower tube and to the side braces.
For 300 l grass catchers only a single lower brace is attached. It is screwed to the side
braces using M5x35 bolts.
33
3.3.2c, note. 5).
3.3.2c
3.3.2d
3.3.2e
3.3.2f
3.3.2g
3.3.2h
3.3.2i
3.3.2j