HOLZMANN MASCHINEN D460FXL 230 V Manual De Instrucciones página 33

12.3 Safety device
If the machine is overloaded, due to e.g. overheating, the overload protection is triggered and
the power supply to the motor is interrupted. The overload protection is reactivated by pressing
the reset button.
12.4 General safety instructions
To avoid malfunctions, damage and health impairments when working with the machine, the
following points must be observed in addition to the general rules for safe working:
• Check the machine for completeness and function before starting. Only use the machine
if the separating and other non-separating protective devices required for machining
have are fitted.
• Make sure that the guards are in good working order and properly maintained.
• Select a level, vibration-free surface as the installation area.
• Ensure sufficient space around the machine. Keep the area around the machine free of
obstacles (e.g. dust, chips, cut-off workpiece parts, etc.).
• Ensure sufficient lighting conditions at the workplace to avoid stroboscopic effects.
• Make sure you have a secure footing when working.
• Ensure a clean working environment.
• Only use tools that are in perfect condition and free of cracks and other defects (e.g.
deformations).
• Remove tool keys and other setting tools before switching on the machine.
• Check the machine's connections for strength before each use.
• Never leave the running machine unattended. Switch off the machine before leaving the
working area and secure it against unintentional or unauthorized restarting.
• The machine may only be operated, maintained or repaired by persons who are familiar
and who have been informed about the dangers arising from this work.
• Ensure that unauthorized persons keep a safety distance from the machine and keep
children away from the machine.
• Always work with care and the necessary caution and never use excessive force.
• Do not overload the machine.
• Only work in well-ventilated rooms.
• Hide long hair under hair protection.
• Wear close fitting protective work clothing and suitable protective equipment (eye
protection, dust mask, ear protection, safety shoes).
• Never wear loose jewellery, loose clothing or accessories (e.g. tie, scarf).
• Do not work on the machine if you are tired, not concentrated or under the influence of
medication, alcohol or drugs!
• Ensure proper connection to the dust extraction system.
• Do not use the machine in areas where vapors of paints, solvents or flammable liquids
represent a potential danger (danger of fire or explosion!).
• Shut down the machine and disconnect it from the power supply, before adjustment,
changeover, cleaning, maintenance or repair work, etc. Before starting work on the
machine, wait until all tools or machine parts have come to a complete standstill and
secure the machine against unintentional restart.
• Warning signs and/or stickers on the machine that are illegible or have been removed
must be replaced immediately!
12.5 Electrical safety
• Make sure that the machine is grounded.
• Only use suitable extension cables.
HOLZMANN MASCHINEN GmbH
• The reset button of the overload protection is located on the
backside of the switch unit (1).
www.holzmann-maschinen.at
SAFETY
33
D460FXL_230V