HOLZMANN MASCHINEN D460FXL 230 V Manual De Instrucciones página 40

Front machining
With optionally available clamping devices you can clamp larger workpieces securely and firmly,
see chapter ACCESSORIES.
Position the tool rest
- Position the tool rest, depending on the turning tool, just above or just below the centre
line of the workpiece at a distance of 1–3 mm.
- Use the tool rest to safely guide and support the turning tool.
Switch the machine on and off
Risk of injury from parts flying off!
 Before switching on the machine, check, whether
the face plate and/or the spur center, the tailstock,
the centre punch tip and
the tool rest are fixed.
Make sure that the workpiece is firmly clamped!
 Do not machine the workpiece with the tool until the machine has reached the
set spindle speed.
Do not increase the spindle speed until the workpiece has reached a regular

runout in its basic shape.
HOLZMANN MASCHINEN GmbH
Spur center
• Attach the workpiece by drilling the claws of the spur
center into the workpiece (2).
Centre punch tip
• Loosen the locking handle (3).
• Turn the handwheel (4) until the centre punch tip has
bored a few mm into the workpiece (5).
• Fix the locking handle again (3).
Face plate
• Fix the workpiece with suitable Spax screws, which are
drilled into the workpiece through the holes in the face
plate (6).
NOTE:
The Spax screws are not included in delivery content!
Make sure that the Spax screws do not penetrate the area of
the workpiece where material is to be removed.
• Screw the face plate with the attached workpiece onto the
thread of the headstock shaft.
WAR N I N G
N O TE
Switch on
• Press the switch-on button (1) of the switch unit.
Switch off
• Set the lowest spindle speed with the rotary regulator (2).
• Press the switch-off button (3) of the switch unit.
www.holzmann-maschinen.at
OPERATION
40
D460FXL_230V