HOLZMANN MASCHINEN D460FXL 230 V Manual De Instrucciones página 37

14.4 Settings
Headstock
Tailstock
Spindle speed
Risk of injury from flying parts!
 Always set the lowest spindle speed for unknown types of wood, for new
workpieces and for large workpieces!
Carefully increase the spindle speed!

The machine has a 3-step pulley arrangement for positioning the drive belt.
HOLZMANN MASCHINEN GmbH
Tool rest
• Position the tool rest base along the machine bed and fix it
with the locking lever (4).
• Position the tool rest into the opening provided (5), set the
desired height and fix it with the locking handle (6).
• If necessary, turn the tool rest.
Spur center
• Push the spur center into the headstock receptacle (1) with
a jerk.
• To remove it, push the fixing rod into the rear end of the
headstock shaft (2). The spur center comes out of the
headstock receptacle.
Face plate
• Screw the face plate onto the thread of the headstock
shaft (3).
• To loosen the face plate, fix the headstock shaft (4) with the
fixing rod and at the same time unscrew the face plate
with the open end wrench (5).
Position
• Open the locking handle (6) and move the tailstock along
the machine bed, depending on the workpiece size.
• Fix the locking handle (6) again.
Centre punch tip
• Push the centre punch tip into the tailstock receptacle (7)
with a jerk.
• To remove it, push the fixing rod into the end of the
tailstock shaft (8).
C AU TI O N
www.holzmann-maschinen.at
ASSEMBLY
37
D460FXL_230V