Kärcher Chariot CV 60/1 RS KIRA Autonomous Manual De Instrucciones página 34

Maintenance
Error Codes Table, cont.
Code
Drive Motor Unknown Motor Controller
17
18
Drive Motor External Temperature
19
1A Drive Motor Open Circuit
1B
1C
1D Vacuum Motor Low FET Error
1E Vacuum Motor High FET Error
Vacuum Motor Internal Motor
1F
Vacuum Motor Unknown Motor
20
21 Vacuum Motor Overcurrent Error
22 Vacuum Motor Open Circuit
23 Clogged Hose, Hopper, or Bag
24
25 Traction Motor DMC Over Temperature
26 Brush Motor DMC Over Temperature
Side Broom Motor DMC Over
27
28 Vacuum Motor DMC Over Temperature
34
Description of Code
Error
Brake Detect Error
Sensor Error
Drive Motor Overheat
Vacuum Motor Short
Controller Error
Controller Error
Actuator Overcurrent
Temperature
8.644-976.0 Manual Operator CV601 RS KIRA
Corrective Actions –
If the problem persists, call for service
Disconnect power with the main breaker, remove the
brush tray and clean the brushes.
Turn the main breaker off and wait 10 seconds before
turning it back on.
Turn the main breaker off and wait 10 seconds before
turning it back on.
Locate the traction motor circuit breaker and reset..
Allow the traction motor cool down for 1 hour before
continuing operation
Turn the main breaker off and wait 10 seconds before
turning it back on.
Turn the main breaker off and wait 10 seconds before
turning it back on.
Disconnect power with the main breaker, remove the side
broom and clean.
Locate the side broom circuit breaker and reset.
Turn the main breaker off and wait 10 seconds before
turning it back on.
Turn the main breaker off and wait 10 seconds before
turning it back on.
Locate the vacuum motor circuit breaker and reset.
Change the vacuum bag.
Inspect the vacuum hose and hopper and clear any clogs.
Turn the main breaker off and wait 10 seconds before
turning it back on.
Disconnect power with the main breaker.
Remove the side broom and clean.
Remove the brush tray and clean the brushes.
Allow the controllers to cool down for 1 hour before
continuing operation.
Disconnect power with the main breaker.
Remove the side broom and clean.
Remove the brush tray and clean the brushes.
Allow the controllers to cool down for 1 hour before
continuing operation.
Disconnect power with the main breaker.
Remove the side broom and clean.
Remove the brush tray and clean the brushes.
Allow the controllers to cool down for 1 hour before
continuing operation.
Disconnect power with the main breaker.
Remove the side broom and clean.
Remove the brush tray and clean the brushes.
Allow the controllers to cool down for 1 hour before
continuing operation.