Teac W-6000R Manual Del Usuario página 13

Amplifier
C=
Q Spare AC outlet
Audio timer
1__ime
<| oa
AC power
When the preset start time is reached, power
will be supplied and recording will start
automatically.
Continuous recording with cassettes
loaded in both Decks | and II and the REV
MODE switch in the C=> position, is
Possible using the timer. For continuous
recording, see page 11.
Timer playback
. Connect this unit and stereo system to a
commercially available audio timer as
shown in the diagram.
. Set the power switches of all components
to ON.
3. Load a prerecorded cassette in Deck | or
ll (or both decks for continuous
playback).
4, Set the REV MODE switch to the
required position. (Refer to "Tape Travel
Depending on Setting of REV MODE
Switch" on page 6.)
5. Set the TIMER switch to the PLAY
Position.
. Set the DOLBY NR switch(es) as desired.
Set the tape running direction in which
playback is to start for Deck | and/or Il.
8. Set the audio timer to the required start
(power on) and stop (power off) times.
When this setting is completed, the power
to all components will be switched off.
ND
When the preset start time is reached, power
will be supplied and playback will start
automatically,
Notes:
@ The tape running direction just before the
power is turned off will be maintained
when the power is turned on again
Remember this when setting timer-
controlled operation.
When cassettes are loaded in both decks
with the REV MODE switch in either ==
or = position, Deck | will start
playback first because it has priority.
When cassettes are loaded in both decks
with the REV MODE switch in
the C= position, continuous playback is
Possible. See page 7.
Be sure to set the TIMER switch to the
OFF position after timer operation is
completed.
435
MAINTENANCE
The'heads and tape path should be cleaned
and demagnetized periodically.
Cleaning Tape Path
© Apply head cleaning fluid" to a cotton bud
or soft cloth, and lightly rub the heads,
capstans and all metal parts in the tape
path.
Also clean the pinch rollers using rubber
Cleaning fluid".
* Both are available in TEAC Tape
Recorder Cleaning Kits HC-2 and RC-2 in
the U.S.A. or TZ-261 in other areas.
Demagnetizing Heads
Be sure that the power is off, then
demagnetize the heads using a TEAC E-3
demagnetizer. For details of its use, read its
instructions.
Capstans ai
Pinch Rollers |
Erase Head
oH
Record/Play Head