FITFIU ELITE Manual Del Usuario página 105

Problem
Wobbling wheel
Steering not accurate
Frequent punctures
Bicycle has reduced
range
And/or speed
Hub motor makes a
"clicking" noise and has
reduce power and/or
shuts off
No power when the
switch is turned "ON"
Bicycle operates OK
but battery gauge does
not light up
Battery gauge lights
up but bicycle does not
operate
Bicycle runs at
full speed without
pedalling
Battery indicates full
charge when tested
at the charge port but
bicycle does not operate
Throttle (on bicycle so
equipped) does not spring
back to neutral position
Possible Cause
• Axle broken
• Wheel out of true
• Hub comes loose
• Headset binding
• Hub bearings collapsed
• QR mechanism loose
• Wheels not aligned in frame
• Headset loose or binding
• Front forks or frame bent
• Inner tube old or faulty
• Tire thread/casing worn
• Tire unsuited to rim
• Tire not checked after previous puncture
• Tire pressure too low
• Spoke protruding into rim
• Low batteries
• Faulty or old batteries
• Low tire pressure
• Brakes dragging against rim
• Riding in hilly terrain, headwind, etc.
• Low batteries
• Damaged planetary gears
• Blown fuse
• Loose connectors
• Broke wire
• Faulty switch
• Faulty controller
• Loose connectors
• Damaged wires
• Faulty battery gauge
• Faulty brake inhibitor
• Loose motor wire connector
• Faulty sensor
• Faulty throttle
• Faulty controller
• Faulty controller
• Loose connectors
• Poor contact between battery terminals
• Grip jammed against throttle
• Faulty throttle
ELECTRIC BYCICLE SAVAGE
• Replace axle
• True wheel
• Adjust hub bearings
• Adjust headset
• Replace bearings
• Adjust QR mechanism
• Align wheels correctly
• Adjust /tighten headset
• Take bike to a bike shop for possible
frame realignment
• Replace inner tube
• Replace tire
• Replace with correct tire
• Remove sharp object embedded in tire
• Correct tire pressure
• File down spoke
• Charge batteries for recommended time
• Replace batteries
• Inflate tires to recommended pressure
• Adjust brakes and/or rim
• Reduced range to be expected in these
• Types of terrain and/or weather conditions
• Charge batteries for recommended time
• Replace hub motor/wheel
• Replace fuse
• Check all connectors
• Inspect all wires for damage
• Replace switch and retest
• Replace controller and retest
• Check throttle or battery gauge connectors
• Inspect all wires
• Replace battery gauge
• Replace brake inhibitor(s) and retest
• Check motor wire connector
• Replace sensor and retest
• Replace throttle and retest
• Replace controller and retest
• Replace controller
• Check all connectors
• Inspect and clean battery terminals
• Reposition grip so gap between it and
the Throttle is 1-2mm
• Replace throttle
105
Possible solution
EN