Metabo SSP 12 Instrucciones De Manejo página 10

ENGLISH
ENG
Only screwdriving bits suitable for the impact
screwdriver must be used.
Take care when driving in long screws - risk of
slipping.
Mount the machine on the screw only when it is
switched off.
5 Overview
See page 3 (please unfold).
1 Screwdriving bit *
2 Locking sleeve
3 Rotational direction switch /
Transporting safety device
4 Trigger
5 Bit holder
6 Battery pack
7 Button for battery pack release
* not in scope of delivery
6 Special Product Features
The battery-powered impact screwdriver is
characterised above all by low-recoil work at
high torques. This hardly perceptible reaction
force is achieved by means of a rotary percus-
sion mechanism designed for left and right rota-
tion.
7 Initial Operation/Setting
Charge the battery pack before use.
NiCd and NiMH: The battery pack reaches its
full capacity only after being charged and
discharged 5 times (charge cycles).
The maximum number of charge cycles can
only reached if an exhaustive discharge of the
battery pack is avoided. If performance dimin-
ishes, recharge the battery pack.
Store NiMH battery packs when charged and
recharge after 6 months at the latest.
Li-Ion battery packs (12 V)
- If the battery pack is either flat, or has become
overloaded or too warm during operation, then
the electronic system switches the battery pack
off (self-protection mode). To continue using the
battery pack: Insert the battery pack into the
charger, which is ready for use. (Rapid cooling
is possible in the "AIR COOLED" battery
charger.)
10
7.1 Removing/inserting battery pack
Removing
Press battery pack release button (7) and
remove battery pack (6).
Inserting
Insert battery pack (6) until it engages.
7.2 Setting the direction of rotation,
engaging the transporting safety
device (switch-on lock)
Only operate the rotational direction
switch / transporting safety device (3)
when the motor is at standstill.
Operate the rotational direction switch /
transporting safety device (3).
R = Right rotation set
(insert screws)
L = Left rotation set
(remove screws)
0 = Middle position: transportation safety
device
(Switch-on lock) set
7.3 Switching on and off
To switch on: press the trigger switch (4).
Switching off: release the trigger switch(4).
7.4 Stepless adjusting of speed /
tightening torque
Speed and tightening torque can be altered step-
lessly by pressing the trigger (4) firmly or lightly,
thus adapting to working conditions. The lower the
speed, the lower the tightening torque.
7.5 Changing screwdriver bit
Inserting screwdriving bit: Slide locking sleeve
(2) forward and insert screwdriving bit (1) as far as
the stop. Release locking sleeve.
Pull on the screwdriver bit to check that it
is correctly seated.
Removing screwdriving bit: Slide locking sleeve
(2) forward and remove screwdriving bit (1).
Only use screwdriving bits with such
plug-in ends: