Publicidad
Idiomas disponibles
Idiomas disponibles
10
Adjustment menu
O
Contrast : Adjust the screen contrast to match the brightness level in the room.
Pressing-the (2] key toggles between brightness and contrast.
Direct operation
Even if the menu screen does not appear, the contrast can be adjusted by
pressing the ld or B key. If the [Id and Bl keys are pressed at the same time,
the maximum level (100) will be set.
Xt Brightness . Adjust the brightness to match the brightness level in the room so that the
level will be easy to see. Pressing the [2] key toggles between contrast
and brightness.
Note: If the ld and P] keys are pressed at the same time on the
Brightness adjustment screen, the standard level (50) will be set.
Size € Pos. : Press the [2] key to select the zoom / horizontal position
/ horizontal size
/ vertical position / vertical size adjustments.
ZOOM : Both the horizontal and vertical size of the image can be adjusted at the
same time; however, the aspect ratio cannot be changed.
H. Position
: The horizontal position of the image can be adjusted.
[=]
H. Size : The horizontal size of the image can be adjusted.
Note: Setting the image in the center of the screen to start will make the
adjustment easier.
V. Position : The vertica! position of the image can be adjusted.
[1]
V. Size : The vertical size of the image can be adjusted.
Note: Setting the image in the center of the screen to start will make the
adjustment easier.
JQ
Geometry : Press the [2] key to select the vertical pincushion / side pincushion balance
/ trapezoid / parallelogram / Geometry 2 adjustments.
LT
V. Pincushion
: The image can be adjusted for vertical pincushion distortion.
CT
Side Pin. Bal. : The image can be adjusted for the side pincushion balance to
the left and right.
IA
Trapezoid . The image can be adjusted for trapezoidal distortion.
17
Parallelog ram : The image can be adjusted for parallelogram distortion,
D D Geometry 2 | Press the $ key to change the sub OSD screen.
Press the [2] key to select the Top Corner / Bottom Corner /
S-Curve 1 / S-Curve 2 adjustments.
LO
Top Corner : The image can be adjusted for verticai pincushion distortion in
the top corner.
II
Bottom
Corner : The image can be adjusted for vertical pincushion
distortion in the bottom corner.
()
S-Curve
1 : The image can be adjusted for vertical pincushion distortion in
the S-Curve 1.
L]
CL]
E
S-Curve 2 : The image can be adjustedfor vertical pincushion distortion in
the S-Curve 2.
Li
L]
Publicidad
