Publicidad
Idiomas disponibles
Idiomas disponibles
Adjustments (Continued)
Adjustment menu
I
YN
=
O
Z
Lu
Of
Language
: The language of the On-Screen Display can be selected from among
German, French, English, Italian and Spanish.
Select with the [d or BJ keys.
OSD
Position : itis possible to adjust the position that the on-screen panel is to be
displayed.
The panel will rotate in a counterclockwise direction N
time the [2]
key is pressed.
Fi Degauss
. Use this function to reduce the irregular colors in the image. The degaussing
operates for approximately five seconds after selection.
Use this function when irregular colors occur in the image after moving the
monitor or the changing the screen angle.
Note: Be informed that a continued use of this function cannot result in a
satisfactory effect. (Try to keep an interval of about 30 minutes or so
between operations.)
The irregular colors may occur when the display orientation, etc. is
adjusted while the power is ON. (Because it is affected by geomagnetism.)
Use the degauss function to reduce the irregular colors.
Bs, Signal : Use the [4 and BI keys to select either the rear panel input terminal port A
{Mini D-Sub type) or Port B (BNC) type.
This displays the input synchronization signal frequency.
Information on the input screen mode (resolution, horizontal and vertical
synchronization frequency) will be displayed on the display monitor. There are
occasions sometimes when some screen modes in use do not display any
resolution. Direct display allows this to be displayed on screen by pressing the [2]
key even when the menu screen is not displayed.
Self-Test menu (No Signal screen)
This display indicates that the monitor is operating normally. When one of the following
conditions occurs, press one of the 4 operation keys to call the appropriate display.
Error
fH 112.0kHz
fV 170.0
Hz
No
Signal
fH ——.--kHz
fV --.--
Hz
Port
©
Port
©
No signal (The computer is not
The horizontai or vertical sync. signal are outside of the
connected or the mains power to
permitted range (the value of the horizontal sync. signal
the computer is disconnected or
will be displayed in red and the value of the vertical sync.
the input connector in use may
signal will be dispiayed in white).
be deselected.)
13
Publicidad
