Panasonic PanaFlat PF90 Manual De Instrucciones página 9

Installation
@ Connecting Procedures
Turn off your computer.
Connect the signal and power connectors as shown below.
Turn the monitor on, then turn on the computer.
A. IBM PS / 2 or PC / AT compatible models
Rear view CEE-22 connector
AC power cord 15 pin mini
D-Sub cable
@ Connect the supplied 15 pin mini D-Sub cable to the monitor's Port A.
Then connect the other end of the supplied 15 pin mini D-Sub cable to the computer's corresponding
15 pin mini D-Sub video connector.
@ First connect the supplied AC power cord to the CEE-22 connector on the rear of the monitor.
Then connect the other end of the AC power cord to a grounded power outlet.
B. Apple computer
@® Connect the supplied 15 pin mini D-Sub cable to the
monitors Port A.
Then connect the other end of the supplied 15 pin mini
D-Sub cable to a UNIMAC-82D MAC adapter and the other
end of the MAC adapter to the computer's corresponding
15 pin mini D-Sub video connector.
@ First connect the supplied AC power cord to the CEE-22
connector on the rear of the monitor. Then connect the
other end of the AC power cord to a grounded power
outlet.
Panasonic MAC adapter
If you need an adapter and one is not provided by your dealer, call 1-800 PANASYS (1-800-726-2797).
Caution:
To prevent the cable from coming loose, the cable connectors must be securely fastened with screws.
C. BNC connector signal computer
Rear view
GD GEN EM ED
= © 0,0 0 ©
RL
(D Connect the BNC signal cable (Not supplied) BNC connectors to the monitor's Port B.
Then connect the other end of the BNC cable, usually a 15 pin mini D-Sub connector, to the computers
corresponding 15 pin mini D-Sub video connector.
@ First connect the supplied AC power cord to the CEE-22 connector on the rear of the monitor.
Then connect the other end of the AC power cord to a grounded power outlet.
4 Connection of AC Power Supply
If the AC power supply voltage is in the range 100 V to 240 V, either 50 Hz or 60 Hz frequency can be used.
There is no AC 100 V / 240 V selector switch as selection is automatic.
Precaution:
« In order to use the display unit safely, use a power cord that is properly grounded.
+ AC plug cords for the following countries must be used as follows:
US A sn UL Canada ........... CSA
For use in other countries, make sure that the AC cord meets the safety standards of each country.
I
Y)
JJ
g
=
u