Publicidad
Idiomas disponibles
Idiomas disponibles
IMPORTANT NOTICE CONCERNING POWER CORD SELECTION
The power cord set for this unit has been enclosed and has been selected according to the country
of destination and must be used to prevent electric shock. Use the following guidelines if it is
necessary to replace the original cord set, or if the cord set is not enclosed.
The female receptacle of the cord set must meet CEE-22 requirements and will look like Figure 1.
For the United States and Canada:
In the United States and Canada the male plug is a NEMA 5-15 style (Figure 2) and is UL listed and
CSA labelled. For units which are mounted on a desk or table, type SVT or SJT cord sets may be
used. For units which sit on the floor, only SJT type cord sets may be used. The cord set must be
selected according to the current rating for your unit. Please consult Table A for the selection criteria
for power cords used in the United States and Canada. (The cord set is marked with its Cord Type.)
I
Y)
=)
O
Z
LU
For European Countries:
In Europe you must use a cord set which is appropriate for the receptacles in your country.
The cord set is HAR-Certified, and the mark €HAR
will appear on the outer sheath, or on
the insulation of one of the inner conductors.
If you have any questions concerning the proper power cord to use, please consult the dealer from
whom you have purchased your unit.
Table A
Cord Type
Size of Conductors in Cord
Maximum Current Rating of Unit
10 Amps
12 Amps
12 Amps
18 AWG
10 Amps
Kur)
© =
=
(
Figure 1
Figure 2
Federal Communications Commission Requirements
This equipment has been tested and found to comply with the limits for Class B digital devices,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses, and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
-
Reorient or relocate the receiving antenna.
—
Increase the separation between the equipment and receiver.
—
Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
— Consult the dealer or an experienced radio / TV technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: {1) This device may not cause harmful interference, and (2) this device must accept
interference received, including interference that may cause undesired operation.
FCC Warning:
To assure continued FCC compliance, the user must use grounded power supply cord and
shielded interface cable with bonded ferrite cores. If BNC cable is going to be used, use only
shielded BNC (5) cable. Also, any unauthorized changes or modifications to this monitor would
void the user's authority to operate this device.
Publicidad
