Digital laser measure
Rechargeable batteries
A) When measuring from the back edge of the measuring tool, this
applies for high reflectivity of the target (e.g. a wall painted white),
weak background lighting and a 20 °C operating temperature; a
distance-dependent deviation of ±0.05 mm/m must additionally
be factored in.
B) When measuring from the back edge of the measuring tool, this
applies for high reflectivity of the target (e.g. a wall painted white),
strong background lighting, 20 °C operating temperature and high
elevation. In addition, a deviation of ±0.15 mm/m must be taken
into account, depending on the distance.
C) Only non-conductive deposits occur, whereby occasional tempor-
ary conductivity caused by condensation is expected.
The serial number (8) on the type plate is used to clearly identify your
measuring tool.
Inserting/Changing the Battery
Always replace all the batteries/rechargeable batteries
at the same time. Only use batteries/rechargeable bat-
teries from the same manufacturer and which have the same
capacity.
When inserting the batteries, ensure that the polarity is
correct according to the illustration on the inside of the
battery compartment.
Take the batteries out of the measuring tool when you
u
are not using it for a prolonged period of time. The bat-
teries can corrode and self-discharge during prolonged
storage.
Bosch Power Tools
English | 11
GLM 25-23
2 × 1.2 V HR03
1 609 92A 7G5 | (09.05.2023)
(AAA)