Bosch GLM 25-23 Professional Manual Original página 13

Measuring Process
When switching on for the first time, the measuring tool will be
in the length measurement function. When switching on every
subsequent time, the measuring tool will be in the measuring
function that was last used.
The rear edge of the measuring tool is always the reference
level for the measurement.
Apply the measuring tool to the point at which you want to
start the measurement (e.g. wall).
Press the button to switch on the laser beam.
Target the target surface with the laser beam.
Briefly press the
ment.
For more information, you can access the online op-
erating instructions at www.bosch-pt.com/manuals
The measuring tool must not be moved during a meas-
urement. Therefore, place the measuring tool, as far as
this is possible, against or on a firm stop or supporting surface.
The reception lens (10) and the laser beam output (11)
must not be covered during the measuring process.
Basic settings
The measuring tool offers the following basic settings:
– Changing the unit of measurement
– Information on the measuring tool
– QR code for the online operating manual
– Reset to factory settings
– Licence Texts and Legal Notes
Bosch Power Tools
button again to start the measure-
1 609 92A 7G5 | (09.05.2023)
English | 13