Publicidad
Idiomas disponibles
Idiomas disponibles
Settings
Basic operation
The settings for this unit are divided into three groups: MENU 1,
MENU 2 and MENU 3.
MENU 1, MENU 2 or MENU 3 settings will be shown depending on
how the MENU button is pressed.
o Settings are retained even if the power plug is disconnected.
1
Open a settings menu.
Opening MENU 1
1. Press an input selection button to select the input
source to set.
The INPUT knob on the main unit can also be turned to
change the setting.
2. Press the MENU button to show MENU 1.
Opening MENU 2
Press and hold the MENU button.
Opening MENU 3
In MENU 2, select "goto MENU3" (go to MENU 3) and
press and hold the MENU button.
o While making settings, MENU 1, MENU 2 or MENU 3 appears
at the top left of the display.
2
Press the MENU button repeatedly to select the
item to change.
MENU 1
MENU 2
TONE>
VolM>
c
c
BASS>*
Gain>
c
c
MID>*
HPVol>
c
c
TRE>*
Fade>
c
c
Bal>
MTLV>
c
c
Lvl>
DPaOFF>
c
c
Name Edit**
APS>
c
Light>
c
LightLV>
c
CPUdp>
c
goto MENU3>
* This appears only when TONE> is set to ON.
** Depending on the optional board (sold separately), a setting item will be shown after
"Name Edit" when it is installed.
For details, see the Owner's Manual for that optional board.
3
Use the setting adjustment (l/;) buttons to
change the settings.
4
Press the OUTPUT button to end setting mode.
If you do nothing for ten or more seconds, setting mode will end
and ordinary display will resume.
MENU 3
XLR1>
c
XLR2>
c
XLR3>
c
PHONO>
c
THRU>
c
RS232C>
c
TRIG_O>
c
TRGst>
c
SETUP>
c
F/W ver.
21
Publicidad
