Esoteric F-01 Manual Del Usuario página 27

Remote control input (RS-232C) connector
RS232C>***
Set this to ON only when using the remote control input (RS-232C)
connector.
o By default, the setting is OFF.
OFF
The remote control input (RS-232C) connector cannot be used.
ON
The remote control input (RS-232C) connector can be used.
Trigger signal output
TRIG_O>***
o By default, the setting is OFF.
OFF
Do not output trigger signals.
ON
Output trigger signals.
Trigger startup
TRGst>***
This sets the behavior when the unit is turned on by a trigger input
signal.
o By default, the setting is LAST.
LAST
When the unit is turned on by a trigger input signal, it will start in
the state it was in (including input and volume) just before it was
put into standby.
THRU
When the unit is turned on by a trigger input signal, input signals
that are set to THRU> (page 26) are output directly.
o If THRU> is set to OFF, it will start with the state it was in just
before it was put into standby.
Restoring factory settings
SETUP>***
You can restore the factory default settings, erasing all changes in
memory.
Follow the procedures below to initialize the settings.
1. Use the setting adjustment (l/;) buttons to show CLR.
2. Press and hold the MENU button when CLR is shown.
Firmware versions
F/W ver
Press the ; button to show the firmware versions.
I/F v**.**
INP v**.**
"**.**" is the version.
27