Descargar Imprimir esta página

Viking MB 3 RC Manual De Instrucciones página 43

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 113
Switching off self-propulsion
● Release self-propulsion lever (1).
Self-propulsion is switched off and the
lawn mower comes to a standstill.
The engine and blade continue to run.
12. Maintenance
Risk of injury!
Carefully read the section "For your
safety" (
4.), particularly the
subsection "Maintenance and
repairs" (
4.7), and follow all
safety instructions exactly before
performing any maintenance or
cleaning operations on the
machine.
Allow the machine too
cool and detach the
spark plug socket before
performing any
maintenance or cleaning
operations.
Annual service by the specialist dealer:
The lawn mower should be inspected once
annually by a specialist dealer. VIKING
recommends VIKING specialist dealers.
12.1 Cleaning the machine
Maintenance interval:
After each use
Care of the machine will protect it against
damage and extend its service life.
0478 111 9908 N - EN
Risk of injury!
Stop the engine, detach the spark
plug socket and allow the machine
to cool down.
Empty the fuel tank (run empty)
before placing the machine in the
cleaning position.
The machine is only safely in the
cleaning position as shown.
● Set down the upper handlebar
rearwards.
● Place two suitable wooden blocks
(height: 7 - 8 cm) on the ground behind
the machine as shown.
● Lift up the machine at the front at the
wheel fork and place on the wooden
blocks as shown.
Notes on cleaning:
● Clean off dirt using little water, with a
brush or with a cloth. In particular, also
clean the mowing blade. Never spray
water onto engine components, seals
or bearing points.
● First, remove accumulated clipping
deposits using a stick.
● If necessary, use a special cleaner
(e.g. STIHL special cleaner).
14
12.2 Checking blade wear
Maintenance interval:
Before each use
Risk of injury!
Blades are subjected to differing
degrees of wear depending on the
location and duration of use. If you
use the machine on sandy ground
or use it frequently under dry
conditions, the blade will be
subjected to greater loads and will
wear more quickly than the
average. A worn blade may break
off and cause serious injuries. The
instructions for blade maintenance
must therefore always be observed.
● Tilt the mower upwards into the
cleaning position. (
12.1)
● Clean mowing blade (1).
● Use a slide calliper to measure blade
thickness at 5 points at least. In
particular, minimum thickness must
also be ensured in the area of the blade
wings.
● Place a ruler (2) against the front blade
edge as shown and measure
permissible grinding.
Blade thickness: > 2 mm
Permissible grinding: < 5 mm
The blade must be replaced,
– if it is damaged (notches, cracks),
– if the measured values are achieved at
one or more points or are outside the
permissible limits.
15
41

Publicidad

loading

Este manual también es adecuado para:

Mb 3.1 rcMb 3.1 rt