Publicidad
The tank assembly (CT 230) MUST ALWAYS BE lowered/raised using the handles
incorporated in the tank (fig. C, ref. 3). Danger of crushing the limbs.
When the tank assembly (CT230) is raised, the gas spring on the left side of the
machine (fig. T) must be locked in place by turning the green ring to the closed
padlock position to prevent the tanks from closing accidentally.
The tank assembly (CT 160 – CT 230) MUST ALWAYS BE lowered/raised with the
tanks empty.
When the tank assembly (CT230) is raised, the gas spring on the left side of the
machine (fig. T) must be locked in place by turning the green ring to the closed
padlock position to prevent the tanks from closing accidentally.
9.1.
Maintenance - General rules
Performing regular maintenance according to the Manufacturer's instructions improves
performance and extends the working life of the machine.
When cleaning the machine, respect the following:
• avoid the use of high pressure washers. Water could penetrate the electrical
compartment or motors leading to damage or the risk of short circuit;
• do not use steam to avoid the heat warping plastic parts;
• do not use hydrocarbons or solvents as they could damage the cowling and rubber
parts.
9.2.
Routine maintenance
9.2.1 CT 160 basket filter: cleaning
•
remove the basket filter from the water fill hole (fig. I, ref. 5);
•
clean the filter with running water or the detergent solution used on the machine;
•
replace the filter, making sure it is correctly positioned in its housing.
•
put the cap back.
9.2.2 CT 230 basket filter and float switch
• access the dirty water tank by turning the lid (fig. I, ref. 1);
• make sure the dirty water tank is empty;
• remove the float switch guard (fig. I, ref. 2).
• clean the float switch (fig. I, ref. 3) at the front of the dirty water tank, taking care not to
direct the water jet directly against the float switch;
• remote the basket filter from the water fill hole (fig. I, ref. 4);
• clean the filter with running water or the detergent solution used on the machine;
• replace the filter, making sure it is correctly positioned in its housing.
• close the dirty water tank lid (fig. I, ref. 1).
ENGLISH
20
! DANGER
! DANGER
! DANGER
! DANGER
Publicidad
