Publicidad
Idiomas disponibles
Idiomas disponibles
STEP 1
S2
S6
S1
S6
•
Align the left and right support tubes so that you can mount the screws S1.
Screw the four screws S1 (Allen key M8x60) together with the four washers S6 into the support tube.
•
Do not tighten the screws yet.
Screw the four screws S2 (Allen key M8x16) with the four washers S6 into the support tube. Do not
•
tighten the bolts yet.
Do not tighten the screw connections until step 4 has been completed.
STEP 2
S6
(C)
Note: Ensure that the connection cable is not subjected to tensile stress or twisted in the
holder tube.
Place the right bracket holder C on the support tube. Mount the two screws S8 (Allen
•
M8x70) with their washers.
Mount the left bracket holder using the screws S8 (Allen M8x70) and washers S6.
•
36
S2
S6
S8
(C)
S6
S8
S6
4 x
Pull the device control cable from the base
•
through the right bracket tube.
Pull the control cord through the right
•
console bracket C.
4 x
4 x
S1
8 x
(A)
S8
4 x
S6
S1
S2
S6
Publicidad
