SPORTSTECH sTread Lite Instrucciones De Montaje página 50

Refilling Silicone Oil
Turn off the machine and unplug the power cord.
•
Fold up the machine.
•
• There are two red openings on the bottom of the machine.
• Pour a few drops of silicone oil into each opening. Wipe off excess silicone oil if necessary.
Unfold the machine and let it run for a few minutes.
•
• Check the lubrication.
11.4 ADJUSTING THE RUNNING BELT
The running belt is adjusted correctly at the factory. After prolonged use the belt stretches and needs
to be readjusted. There are two adjustment screws for the rear tensioner located behind a cover on the
base unit. To center the belt on the tread and adjust its tension, follow these steps:
• Turn on the machine and allow it to run at 4 - 6 km/h.
If the running belt runs too far to the left, turn the left adjustment screw clockwise ¼ turn with the
•
supplied Allen wrench.
If the running belt runs too far to the right, turn the right adjustment screw ¼ turn clockwise with the
•
supplied Allen wrench.
• Turn both screws until the treadmill is centered on the belt.
• Run on the treadmill.
Tighten the two adjustment screws evenly on both sides until the belt does not slip.
•
Figure 1: Tightening the right
running belt screw
50
Figure 2: Tighten both screws evenly
after the belt is centered on the treadmill
surface.
Tool: Allen key