Publicidad
Idiomas disponibles
Idiomas disponibles
Adjust the angle to set up a good work position for
different operators.
1. Disconnect the motor cable (A) from the electrical
enclosure.
B
2. Remove the lock knob (B).
3. Select the applicable position (C) for the operation
and put the lock knob (B) in correct hole. The
bottom hole increases the grinding pressure and the
height of the handlebar. The top hole decreases the
grinding pressure and the handlebar.
Grinding pressure
Refer to the tables for the grinding pressure against the
surface for each hole position.
Low, kg/lbs
Center, kg/lbs
23/51
25/55*
With accessory counterweight
17/37
20/44*
*Factory setting
Diamond tools
There are many types of diamond tools for the product.
Speak to your approved service center or go to
www.husqvarnacp.com to select correct diamond tool.
Installation of the diamond tools
The installation of the diamond tools on the tool plate
has effect on the performance of the product. The
10
A
C
Top, kg/lbs
27/60
23/51
diamond tool type together with the number of segments
on the diamond tool is important.
Use metal bond diamond tools with 2 segments for
usual grind operations, to make the surface level or light
removal.
Use metal bond diamond tools with 1 diamond segment
to increase the diamond tool pressure. This installation
is for heavy removal with much force.
For the heaviest removal, we recommend to use tools
that only run in one direction with PCD diamond tops.
Note:
™
PIRANHA
tools are made to run only in one
direction.
Metal bond diamond segments
Note:
Husqvarna recommends to use 2 segment
setup.
The setup of the diamond segments on the grinder will
have an influence on the performance. The setup have
an effect on the work rate of the product and the end
quality of the surface.
There are a number of different diamond tool
configurations that can be attached to the product.
•
For PG 280 Full set - inner and outer row. Smooth
surface removal.
•
For PG 280 Part set - inner and outer row. Effective
flat surface removal.
2112 - 002 - 24.10.2023
Publicidad
