Publicidad
Idiomas disponibles
Idiomas disponibles
HID207
User Manual
Counter Installations
Units placed on a counter must either use legs or be
sealed to the counter top with food grade sealant per
local codes. To avoid disturbing the seal, complete the
installation prior to sealing.
Note: Seal Chassis to Counter, do NOT Seal Drip Tray
Legs
4" legs are optional for countertop applications (Part
number:KLP24A). In order to securely fasten the legs,
the rubber feet must be removed. They are not to
be used on the HID dispenser when it is placed on a
machine stand.
Note: Use only legs of 4" minimum height.
Set Up
The drip tray and cup rest are shipped in place, but
they can be easily removed. It is a good idea to
remove the front panel and inspect for any loose or
rubbing parts prior to installation.
Splash Panel Removal
1. Pull outward on drip tray to release from unit.
2. Remove top panel.
3. Swing bottom of panel forward, unplug sensor or
switch connectors and separate panel from unit.
4. Remove screws at top and bottom of front panel.
5. Pull levers at rear of chutes to un-snap ice and
water dispense chutes and remove from panel.
6. Lift splash panel off the unit.
7. Inspect for loose or rubbing parts. Correct as
needed.
8. Return splash panel to its original position and
secure the panel with its screws.
9. Return drip tray to its original position.
Pre-Start Inspection
1. Level the cabinet front to back and left to right.
2. Confirm there are no loose or rubbing parts.
3. Return splash panel and chutes to unit.
HID207AX Shown, HID207ABX Similar
November 2023
Page 6
Splash Panel
Publicidad
