Publicidad
Idiomas disponibles
Idiomas disponibles
HID207
User Manual
Installation Water and Drain
Installation should be done by an experienced ice
machine installer. To locate one, call the number on
the back of this manual or go to Scotsman's website
www.scotsman-ice.com to identify a local distributor or
service company.
The machine will require power, water and drain.
Locate the water supply fitting on the lower back of
the cabinet and obtain the correct fitting to connect
the water supply.
Plumbing Connections:
• Potable water connection: Poly Tubing ¼ O.D. x 6
FT length
• Cabinet drain connection: ¾ I.D. Tubing to accept
¾ Barbed fitting, not included.
All models:
1. Connect the potable water supply to the tubing
at the bottom back of the unit. Water filters may
be used but are not required. A hand shut off
valve within sight of the machine is strongly
recommended
Note that activated carbon or charcoal water filters
are used for taste and odor problems but also take
out any chlorine that the local water agency may have
added for purification. That can require more frequent
sanitization of the equipment.
2. Connect drain tubing to the central drain fitting
at the back of the cabinet. Use 3/4 inch tubing,
use material to meet local codes. The drain basin
in the machine will act as an internal vent, no
additional vent should be required unless there
is a very long horizontal run. Drain tubing must
pitch down 1/4 inch per foot to the building drain.
Insulation of drain tubing is recommended for
most environments.
Potable Water
Connection
Drain Tubing
Power Cord
November 2023
Page 7
Publicidad
