Tenda K8W-3TC Guia De Instalacion página 6

Camera
Fill light
LED
indicator
Ethernet port
Power port
LED indicator
Orientation knob
Power port
Ethernet port
Reset button
(Behind the cover)
Micro SD card slot
(Behind the cover)
Orientation knob
Solid red: Initializing and starting.
Blinking red slowly: Disconnected from a 2.4 GHz Wi-Fi network.
Blinking red quickly: Connecting to the NVR.
Solid blue: Connected to the NVR.
Blinking blue slowly: Upgrading.
Blinking blue quickly: Waiting to connect to a 2.4 GHz Wi-Fi network.
Adjust the monitoring angle for the best view through your camera.
Use the included 12 V 1 A power adapter to power on the camera.
10/100 Mbps auto-negotiation Ethernet port, used for connecting
such devices as the router and switch.
Hold down the reset button for about 5 seconds and release it after
the LED indicator blinks blue quickly or you hear a prompt tone. The
camera is reset to factory settings successfully.
Only used to upgrade the firmware of the camera and does not
support storage.
Microphone
Micro SD
Reset
Speaker
4
Micro SD card slot
(Behind the cover)
Reset button
(Behind the cover)