Tenda K8W-3TC Guia De Instalacion página 7

Install the HDD
If the kit does not include any HDD, please prepare it by yourself. You are
recommended to use the HDD dedicated for surveillance.
Tips
When installing or replacing the HDD, cut off the power of the NVR; otherwise, the HDD
may not be detected or even be damaged.
Unfasten the screws on the bottom, then remove the cover of the NVR.
Reserve the screws for later use.
Take out 2 screws from the NVR installation package, and screw them
into the two screw holes closest to the SATA connector. Reserve about 2
mm between the screw head and the HDD for subsequent installation.
SATA connector
Align the SATA connector of the HDD with the SATA slot on the
motherboard of the NVR, and then insert the HDD into the slot until it is
tightly fixed.
Flip
HDD
Remove the cover
HDD
5