Centuro S2 / S1
| Scooter
Speed setting
You can use these buttons (Fig. 16) to set the maximum speed.
•
Turn the switch to the left ( turtle) to reduce the maximum allowed
speed.
•
Turn the switch to the right (rabbit), to raise up to the maximum al-
lowed speed.
16
Headlight
Use this button (Fig. 17) to switch on the lights on your scooter when
dusk begins to fall or when passing through dark routes such as tunnels.
This will make you more easily visible to other road users.
Diagnostic LED
If the diagnostic LED is constantly lit (Fig. 18) the scooter is fully func-
17
tional.
If a fault occurs, this is indicated by flashing. First check the battery sta-
tus and whether the drives are connected. If the LED continues to flash,
contact your mobility dealer.
Battery Status Display
The battery status display (Fig. 19) shows to what extent the batteries are
charged. If all ten bars are visible, the battery is fully charged.
18
As you use the scooter, the battery capacity decreases and fewer bars
are displayed. If only two bars are displayed, this means that only short
journeys can now be made and the battery should be recharged (see
charging).
19
60
Indicators (left/right)
Use this button (Fig. 20) to switch on the left or right indicator on your
scooter to signal to other road users that you wish to turn left/right.
Pressing the button again turns the indicator off again. After flashing 15
times the signal turns off automaticly.
Horn
The horn (Fig. 21) enables you to draw attention to yourself in difficult
situations.
Ignition key
Switch the scooter off and on using the ignition key (fig. 22).
6.2. Getting in and out
Ensure that the scooter is switched off before sitting on it.
•
Move the steering column, as described previously, into the upright
position and swivel back the arm rest on the side from which you
intend to sit down so that the arm rest is out of the way.
•
It is easier for you to sit down if you rotate the seat 90° to the side
from which you intend to sit down (see the section entitled Basic
adjustments).
•
Now sit down.
•
Rotate the seat in the driving direction or swivel the arm rest forwards
again (chap. 5.).
Ensure that the seat firmly locks in position
again.
•
Adjust the steering column so that you can comfortably reach all the
controls.
•
To get out, follow the instructions accordingly in reverse order.
However, take out the key beforehand so that you can ensure that no
unintended actions or movements occur.
Bischoff & Bischoff GmbH |2023.12.12 - Rev. 3
Centuro S2 / S1
Scooter |
20
21
22
61