Publicidad
Idiomas disponibles
Idiomas disponibles
width to between 80 and 450 μs. You can also set the working time and
pause time for this program to between 1 and 30 seconds each.
1. Place the electrodes on the desired area for treatment (for positioning
suggestions see electrode positions in section "7.4 Information regard-
ing the positioning of electrodes") and connect them to the device.
2. Select the EMS 34 program as described in section "5.2 Starting use"
(step 3 to step 5).
3. Use the / setting buttons to select the 'on time' you want and press
the ENTER button to confirm your selection..
4. Use the / setting buttons to select your preferred 'off time' and press
the ENTER button to confirm.
5. Use the / setting buttons to select the impulse frequency you want
and press the ENTER button to confirm your selection.
6. Use the / setting buttons to select your preferred impulse width and
press the ENTER button to confirm.
7. Use the / setting buttons to select the treatment time you want and
use the ENTER button to confirm.
8. Use the left and right / setting buttons for
the impulse intensity you want.
EMS 35 program
The EMS 35 program is a burst program that you can also customise.
Various impulse sequences run in this program. Burst programs are suita-
ble for all areas of application to be treated with changing signal patterns
(to minimise the level of becoming accustomed to the treatment). In this
program, you can set the impulse frequency to between 1 and 150 Hz and
the impulse width to between 80 and 450 μs. You can also set the working
time and pause time for this program to between 1 and 30 seconds each.
1. Place the electrodes on the desired area for treatment (for positioning
suggestions see electrode positions in section "7.4 Information regard-
ing the positioning of electrodes") and connect them to the device.
2. Select the EMS 35 program as described in section "5.2 Starting use"
(step 3 to step 5).
3. Use the / setting buttons to select the 'on time' you want and press
the ENTER button to confirm your selection..
4. Use the / setting buttons to select your preferred 'off time' and press
the ENTER button to confirm.
5. Use the / setting buttons to select the impulse frequency you want
and press the ENTER button to confirm your selection.
6. Use the / setting buttons to select your preferred impulse width and
press the ENTER button to confirm.
7. Use the / setting buttons to select the treatment time you want and
use the ENTER button to confirm.
8. Use the left and right / setting buttons for
the impulse intensity you want.
11. DOCTOR'S FUNCTION
The Doctor's function is a special setting to allow you to access your
personal program even more easily and directly.
Your individual program settings are instantly recalled and activated when
and
to select
the device is switched on.
You may wish to adjust this individual program following advice from your
doctor.
Setting the Doctor's function
• Select your program and the corresponding settings as described in
section "5.2 Starting use".
• At the start of the stimulation treatment, the impulse intensity of
electrodes yet. Before setting the desired impulse intensity using
the intensity setting buttons, press and hold the
5 seconds. Storage in the Doctor's function is confirmed by a long
acoustic signal.
• When you switch on the device again, the program you saved using
the Doctor's function is automatically opened directly.
34
and
is set to 00 by default. No impulses are sent to the
and
to select
button for
Publicidad
