American Standard Aspirations 7061857 Manual Del Propietário página 5

6
MARK SCREW HOLE LOCATIONS
Optional: The control box can be mounted with the hook and loop fastener rather than screws if desired.
• Remove COVER PLATE (1) by removing the tape on the side of the box.
• Using the CONTROL BOX BACK (3) as a template, mark the two SCREW HOLE LOCATIONS (2)
with a pen or pencil.
NOTE: Control box must be located within the 14" by 21" shaded area shown.
1
SUPPLIES
WASTE
21"
(mm)
LAVATORY RIM OR
MOUNTING SURFACE
14"
(356mm)
1
1524mm
(60)
20"
(500mm)
2 2
3