Publicidad
Idiomas disponibles
Idiomas disponibles
EN ENGLISH
4.7 Additional Safety Instructions
WARNING – Always wear protective goggles.
Use elastic cushioning layers if they have been supplied with the abrasive and if required.
Observe the specifications of the tool or accessory manufacturer! Protect the discs from
grease or impacts!
Grinding discs must be stored and handled with care in accordance with the manufacturer's
instructions.
Never use cutting discs for roughing work! Do not apply pressure to the side of cutting discs.
The workpiece must lay flat and be secured against slipping, e.g. using clamps. Large work-
pieces must be sufficiently supported.
If accessories with threaded inserts are used, the end of the spindle may not touch the base
of the hole on the grinding tool. Make sure that the thread in the accessory is long enough
to accommodate the full length of the spindle. The thread in the accessory must match the
thread on the spindle. See page 3. Technical Specifications for more information on the
spindle length and thread.
Use of a fixed extractor system is recommended.
Dust from material such as paint containing lead, some wood species, minerals and metal
may be harmful. Contact with or inhalation of the dust may cause allergic reactions and/or
respiratory diseases to the operator or bystanders.
Certain kinds of dust are classified as carcinogenic such as oak and beech dust especially
in conjunction with additives for wood conditioning (chromate, wood preservative). Material
containing asbestos must only be treated by specialists.
- Where the use of a dust extraction device is possible it shall be used.
- The work place must be well ventilated.
- The use of a dust mak with a filter call P2 is recommended.
Follow national requirements for the materials you want to work with.
Materials that generate dusts or vapours that may be harmful to health (e.g. asbestos) must
not be processed.
When working in dusty conditions, ensure that ventilation openings are not blocked. If it
becomes necessary to remove dust, first remove the battery pack (use non-metallic objects)
and avoid damaging internal components.
Damaged, non-centered or vibrating tools must not be used.
Avoid damage to gas or water pipes, electrical cables and load-bearing walls (static).
Remove the battery pack from the machine before any adjustments, conversions or servicing
are performed.
Before fitting the battery pack, make sure that the machine is switched off.
A damaged or cracked handle must be replaced. Never operate a machine with a defective
handle.
A damaged or cracked safety guard must be replaced. Never operate a machine with a
defective safety guard.
10
Walter Surface Technologies Inc. - ZIPWHEEL cutter
Zipwheel cutter 34A150...760 Manual-REV2.221214.indd 10
2015-01-22 9:50 AM
Publicidad
