Publicidad
Idiomas disponibles
Idiomas disponibles
EN ENGLISH
8.2 Working instructions
Cutting off:
Do not «jam» the cut-off wheel or apply excessive pressure. Do not attempt to make an
excessive depth of cut. Overstressing the wheel increases the loading and susceptibility to
twisting or binding of the wheel in the cut and the possibility of kickback or wheel breakage.
Always work against the run of the disc (see illustration). Otherwise there is
the danger of the machine kicking back from the cut out of control. Guide the
ma chine evenly at a speed suitable for the material being processed. Do not
tilt, apply excessive force or sway from side to side.
Sanding:
Press down the machine evenly on the surface and move back and forth so that the surface
of the workpiece does not become too hot.
Wire brushing:
Press down the machine evenly.
9. Cleaning
Clean the dust fi lter regularly: remove and clean with a jet of compressed air.
10. Troubleshooting
The electronic signal display (7) lights up and the load speed decreases. The
temperature is too high! Run the machine in idling until the electronic signal indicator swit-
ches off.
The electronic signal display (7) fl ashes and the machine does not start. The
restart protection is active. The machine will not start if the battery pack is inserted while the
machine is on. Switch the machine off and on again.
11. Accessories
Use only genuine Walter Surface Technologies Inc. accessories. See page 4.
Use only accessories which fulfi l the requirements and specifi cations listed in these opera-
ting instructions.
A Ventilated charging station
B Battery pack
C Safety guard for cut-off grinding
Designed for work with cut-off wheels, diamond cut-off wheels.
D Hand guard for sanding and wire brushing operations
Designed for work with support plates, sanding pads, wire brushes.
Install hand guard under the additional side- mounted handle.
16
Walter Surface Technologies Inc. - ZIPWHEEL cutter
Zipwheel cutter 34A150...760 Manual-REV2.221214.indd 16
2015-01-22 9:50 AM
Publicidad
