Publicidad
Idiomas disponibles
Idiomas disponibles
EN ENGLISH
6. Initial Operation
6.1 Attaching the side handle
Always work with the side handle attached (13)! Attach the side handle on the left or
right of the machine and secure.
6.2 Installing safety guard
For safety reasons, always use the safety guard provided for the respective wheel!
See also chapter 11.
Safety guard for cutting-off
See illustration E on page 2.
- Pull on the lever (17). Place the safety guard (14) in the position indicated.
- Release the lever and turn the safety guard until the lever engages.
- Pull on the (17) lever and turn the safety guard until the closed section is facing the operator.
- Make sure that the guard is seated securely : the lever must be engaged and you should
not be able to turn the safety guard.
6.3 Dust filter
See illustration A on page 2.
Always use the dust filter if the surroundings are heavily polluted (12).
The machine heats up faster when the dust filter is attached (12). It is protected by
the electronics system from overheating (see chapter10.).
To install:
See fig. page 3. Attach the dust filter (12) as shown.
To remove:
Holding the dust filter at the edges, raise it slightly (12) and then pull it downwards and re-
move.
6.4 Rotating battery pack
See illustration B on page 2.
The rear section of the machine can be rotated 270° in three stages, thus allowing the ma-
chine's shape to be adapted to the working conditions. Only operate the machine when it is
in an engaged position.
12
Walter Surface Technologies Inc. - ZIPWHEEL cutter
Zipwheel cutter 34A150...760 Manual-REV2.221214.indd 12
Use only accessories that are covered by at least 3.4 mm by
the safety guard.
2015-01-22 9:50 AM
Publicidad
