Publicidad
Idiomas disponibles
Idiomas disponibles
ENGLISH EN
4. Special Safety Instructions
4.1 Safety Warnings Common for Cutting-off, Grinding, Sanding, Wire Brushing
Operations:
a) This power tool is intended to function as a cut-off tool, grinder, sander, or wire
brush tool. Read all safety warnings, instructions, illustrations and specifications pro-
vided with this power tool. Failure to follow all instructions listed below may result in elec-
tric shock, fire and/or serious injury.
b) Operations such as polishing are not recommended to be performed with this
power tool. Operations for which the power tool was not designed may create a hazard and
cause personal injury.
c) Do not use accessories which are not specifically designed and recommended by
the tool manufacturer. Just because the accessory can be attached to your power tool, it
does not assure safe operation.
d) The rated speed of the accessory must be at least equal to the maximum speed
marked on the power tool. Accessories running faster than their rated speed can break
and fly apart.
e) The outside diameter and the thickness of your accessory must be within the capa-
city rating of your power tool. Incorrectly sized accessories cannot be adequately guarded
or controlled.
f) Threaded mounting of accessories must match the grinder spindle thread. For ac-
cessories mounted by flanges, the arbour hole of the accessory must fit the locating
diameter of the flange. Accessories that do not match the mounting hardware of the power
tool will run out of balance, vibrate excessively and may cause loss of control.
g) Do not use a damaged accessory. Before each use inspect the accessory such as
abrasive wheels for chips and cracks, backing pad for cracks, tear or excess wear,
wire brush for loose or cracked wires. If a power tool or accessory is dropped, ins-
pect for damage or install an undamaged accessory. After inspecting and installing an
accessory, position yourself and bystanders away from the plane of the rotating ac-
cessory and run the power tool at maximum no-load speed for one minute. Damaged
accessories will normally break apart during this test time.
h) Wear personal protective equipment. Depending on application, use face shield,
safety goggles or safety glasses. As appropriate, wear dust mask, hearing protectors,
gloves and workshop apron capable of stopping small abrasive or workpiece frag-
ments. The eye protection must be capable of stopping flying debris generated by various
operations. The dust mask or respirator must be capable of filtering particles generated by
your operation. Prolonged exposure to high intensity noise may cause hearing loss.
i) Keep bystanders a safe distance away from work area. Anyone entering the work
area must wear personal protective equipment. Fragments of workpiece or of a broken
accessory may fly away and cause injury beyond immediate area of operation.
j) Hold power tool by insulated gripping surfaces only, when performing an operation
where the cutting accessory may contact hidden wiring or its own cord. Cutting acces-
sory contacting a «live» wire may make exposed metal parts of the power tool «live» and
shock the operator.
k) Position the cord clear of the spinning accessory. If you lose control, the cord may be
cut or snagged and your hand or arm may be pulled into the spinning accessory.
I) Never lay the power tool down until the accessory has come to a complete stop. The
spinning accessory may grab the surface and pull the power tool out of your control.
Walter Surface Technologies Inc. - ZIPWHEEL cutter
7
Zipwheel cutter 34A150...760 Manual-REV2.221214.indd 7
2015-01-22 9:50 AM
Publicidad
