Walter ZIPWHEEL 34-A 150 Manual página 13

6.5 Battery pack
Charge the battery pack before use (11).
If performance diminishes, recharge the battery pack.
The ideal storage temperature is between 10°C and 30°C.
«Li-Power» li-ion battery packs have a capacity and signal indicator: (10)
- Press the button (9), the LEDs indicate the charge level.
- If one LED is flashing, the battery pack is almost flat and must be recharged.
6.6 Removing and inserting the battery pack
Removal:
Press the battery pack release (8) button and pull the battery pack (11) forwards.
Inserting:
Slide in the battery pack (11) until it engages.
7. Attaching the cut-off wheel
Before carrying out any modifications: remove the battery pack from the machine.
The machine must be switched off and the spindle at a standstill.
For reasons of safety, attach the cutting guard before performing cutting work (see
chapter 11 Accessories).
7.1 Locking the spindle
- Depress the spindle locking button (5) and turn the spindle (4) by hand until you feel the
spindle locking button engage.
7.2 Placing the cutting wheel in position
See illustration C on page 2.
- Attach the support flange (3) on the spindle. The flange should not turn on the spindle when
properly attached.
- Place the cutting wheel on the support flange (3). The cutting wheel must lay flat on the
supporting flange. The metal flange on the cutting discs must lay flat on the support flange.
Note: The support flange (3) is secured to prevent it from falling off. To remove: use some
force if necessary.
Zipwheel cutter 34A150...760 Manual-REV2.221214.indd 13
Walter Surface Technologies Inc. - ZIPWHEEL cutter
ENGLISH EN
13
2015-01-22 9:50 AM