Fronius OPT/i FumeEx Manual De Instrucciones página 33

Troubleshooting
Troubleshooting
Porosity of weld seam
Cause:
Remedy:
Extraction too low
Cause:
Remedy:
Cause:
Remedy:
Cause:
Remedy:
Cause:
Remedy:
Extraction too strong
Reduce extraction - see section
ge 31.
Holes in the extraction hose
Replace extraction hose
Displaced extraction unit filter
Replace extraction unit filter
Air passages otherwise blocked
Remove blockages
Extraction capacity of the extraction unit too low;
incorrect configuration of OPT/i FumeEx
Use extraction unit with greater extraction capacity;
Increase extraction capacity of OPT/i FumeEx - see section
sing extraction capacity
Reducing extraction capacity
on page 29.
on pa-
Increa-
33