Parkside PSBM 1100 B1 Traduccion Del Manual De Instrucciones Originale página 10

Depth stop
♦ Undo the screw on the depth stop
♦ Insert the depth stop
handle .
♦ Make sure that the teeth on the depth stop
point upwards and downwards.
♦ Pull the depth stop
between the tip of the drill and the tip of the
depth stop corresponds with the required drilling
depth.
♦ Tighten the screw on the depth stop
lock the depth stop
Changing tools
The appliance has a fully automatic spindle lock.
♦ When the motor is stopped, the power train
locks so that the quick-release chuck
opened by turning it towards
♦ Insert the desired tool into the quick-release
chuck .
♦ Turn the quick-release chuck
LOCK
to tighten the tool.
♦ The spindle lock is automatically released when
the motor starts (ON/OFF switch
Operation
Select operating mode
Function selector switch
♦ Move the function selector switch
required symbol engages:
Function
Drilling
Impact drilling
PSBM 1100 B1
All manuals and user guides at all-guides.com
.
into the additional
out until the distance
to
into place.
can be
UNLOCK .
towards
pressed).
so that the
Symbol
Select direction of rotation
WARNING!
► The rotation direction switch
used/adjusted if the device is at a standstill.
♦ Select the direction of rotation by pressing the
rotation direction switch
right.
2-speed gearbox
CAUTION!
► Operate the speed selector
the appliance is at a standstill. Otherwise,
the appliance can be damaged. If it is not
possible to move the selector, briefly press
the ON/OFF switch
► Press the speed selector
in the lower half of the dial! Turn
the speed selector
required gear engages at the
marking.
In first gear
(speed selector switch
This setting is suitable for light drilling, pre-drilling,
work using a large-diameter drill, and the use of
accessories.
In second gear
(speed selector switch
This setting is suitable for carrying out drilling work
with a small-diameter drill.
Preselecting the rotation speed
You can use the rotational speed preselector
adjusting wheel
speed. The speed you select depends on the mate-
rial to be processed. Work out the correct settings
by carrying out a test.
NOTE
► The appliance only reaches the set rotational
speed during continuous operation.
may only be
towards the left or
only when
and then try again.
only
so that the
in position 1)
in position 2)
to preselect the rotational
GB │ IE │ 7 ■