Parkside PSBM 1100 B1 Traduccion Del Manual De Instrucciones Originale página 9

Appliance-specific safety instructions
WARNING! TOXIC DUST!
► Working with the tool can produce harmful/
toxic dusts which represent a health hazard
for the person operating the appliance and
for anyone else in the vicinity.
■ CAUTION: SUPPLY LINES! DANGER!
Ensure that you are not likely to hit power, gas
or water supply lines when you are working
with the power tool. If necessary, check with a
service line detector before you start to cut or
drill into a surface.
■ Collect any dust that may accumulate, e.g. with
a vacuum cleaner.
Residual risks!
Even if you operate this power tool properly, there
will still be residual risks. The following risks can
occur in relation to the power tool's design and
structure:
1. Lung damage, if no suitable dust protection
mask is worn.
2. Hearing damage, if no suitable hearing protec-
tion is worn.
3. Damage to health caused by hand-arm vibra-
tions if the appliance is used for extended
periods or is not properly used and maintained.
WARNING!
► The power tool creates an electromagnetic
field during operation. This field can, in
certain circumstances, impair active or
passive medical implants. To reduce the risk
of fatal injuries, we recommend that people
with medical implants consult their doctor and
the manufacturer of the medical implant
before operating this machine.
■ 6 │ GB │ IE
All manuals and user guides at all-guides.com
Original accessories/auxiliary
equipment
■ Use only the accessories and additional equip-
ment that are specified in the operating instruc-
tions and are compatible with the appliance.
Setting up
WARNING!
► Switch the appliance off and remove the
power plug before starting any work on the
appliance.
Additional handle
NOTE
► For safety reasons, you should only use this
appliance with the additional handle
attached.
♦ Loosen the strap on the additional handle
by turning it anticlockwise.
♦ Push the additional handle
release chuck .
♦ Turn the additional handle
position.
♦ Turn the additional handle
to tighten it.
NOTE
► Move the additional handle
various locking positions depending on your
working position. Undo and lock the addi-
tional handle as described previously.
over the quick-
to the required
clockwise again
into the
PSBM 1100 B1