Sanding Bands; Engraving Cutters - Genesis GRT2103-40 Manual Del Operario

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

gUIDE FOR ROTARY TOOL BITS
NOTE: This Rotary Tool may not include all of the accessories described.

SANDINg BANDS:

Sanding Bands of Different Grits and Sizes are used to sand curves in wood or plastic. use a larger
Sanding Band for curves with a larger arc. finer grits give a smoother finish; coarser grits offer more
aggressive sanding. Choose a Sanding Mandrel that matches the Band you want to use. Loosen the
screw in the top of the Sanding Mandrel. Slide the Band over the mandrel, and tighten the screw to
expand the rubber drum and secure the band.
WIRE BRUSHES:
Wire Brushes and Cup Wheels are for smoothing, de-burring, and cleaning metal surfaces. use to
remove paint, rust, corrosion, and weld slag.
Brushes should be run at operating speed for at least one minute before using. This allows loose wires
and bristles to be discharged prior to work application. Wire and bristle brushes must never be operated
at speeds greater than 15,000 rpm. Bristles or wires can be thrown from the brush at higher speeds.
15,000 RPM is approximately halfway on the speed dial of your variable speed rotary tool. Do not use
on the mini-Rotary Tool. Wear protective gloves and face shield when using wire brushes.
The Silver/Grey brushes are carbon steel general-purpose brushes. The Gold/yellow Brushes are Brass
Brushes, which will work better on softer metals like Copper, brass, or precious metals.
BRISTLE BRUSHES:
Bristle Brushes are for cleaning and de-burring softer, delicate, or antique metals (such as Gold and
Silver) and various non-metallic surfaces such as graphite and rubber. use with polishing compound for
faster results.
ALUMINUM OXIDE SAND PAPER, gRINDINg STONES,
WHEELS AND POINTS (RED/BROWN):
Aluminum Oxide Bits are for grinding and shaping metals of all kinds. Sharpen scissors, screwdriver
Tips, Tools, Blades, Milled, uneven surfaces. De-burr metal pieces after cutting. Clean up welds. Remove
Rust. Re-sharpen with provided dressing stone.
SILICON CARBIDE gRINDINg STONES, WHEELS & POINTS (BLUE):
Silicon Carbide Bits are for grinding and shaping very hard materials, such as glass, ceramics, and
stone. Re-sharpen with provided dressing stone.
DIAMOND gRINDINg POINTS:
Diamond Grinding Points in many shapes and sizes can be used to shape, cut, carve, and engrave in
very hard materials such as brick, masonry, concrete, glass, ceramics, porcelain, and stone.

ENgRAVINg CUTTERS:

engraving Cutters of Different Shapes and Sizes are used for intricate engraving, routing, and carving
in wood, plastic, and soft metals.
11

Publicidad

Tabla de contenido
loading

Tabla de contenido