cecotec CONGA CONNECTED Manual De Instrucciones página 46

ENGLISH
Free-fall sensors cleaning
Use a clean, dry and soft cloth to wipe off any dust from the free-fall sensor located on the
robot lower part.
Warning
Do not apply cleaning products directly on the sensors.
Cleaning the silicone brush
1. Slightly press the silicone brush frame tabs in order to open the slot and remove it. Fig. 26
2. Remove any hair, lint or other dirt trapped in the brush and around the shafts.
3. Clear and clean the robot suction channel. Fig. 27
4. Reinstall the silicone brush and its frame.
Cleaning the Jalisco brush
The Jalisco brush is designed for hard floors. Its micro-fibre technology captures dust, sand,
mites and lint efficiently in a single pass. This brush is in contact with the floor, and therefore
with dirt, so it can be worn out over time, affecting negatively to the cleaning efficiency. For
this reason, it is suggested to replace the Jalisco brush after a maximum of 320 hours or less.
1. Slightly press the Jalisco brush frame tabs in order to open the slot and remove it. Fig. 26
2. Remove any hair, lint or other dirt trapped in the brush and around the shafts.
3. Clear and clean the robot suction channel. Fig. 27
4. Reinstall the Jalisco brush and its frame.
Side brushes
Side brushes are designed with multiple bristles and are used to push dirt towards the suction
nozzle and to thoroughly clean edges and corners. These brushes can wear out over time,
affecting negatively to the cleaning efficiency. For this reason, it is suggested to replace each
side brush after a maximum of 220 hours or less.
Recommendation
It is recommended to clean the side brushes once a week with the help of the cleaning brush.
Sensors
- Your robot vacuum cleaner has different types of sensors, for example, proximity sensors
that allow the robot to move around while detecting obstacles, or free-fall sensors that
help the robot detect slopes or possible gaps/unevenness such as staircases. These
sensors are always in contact with dust particles, and therefore can be blocked over time,
causing possible navigation errors.
It is suggested to clean all the robot sensors with the cleaning brush or with a dry, soft
-
cloth after a maximum of 35 hours of operation or less.
46