cecotec CONGA CONNECTED Manual De Instrucciones página 47

Battery charge and replacement
To lengthen the battery shelf life, keep the robot charging on the charging base when not
-
in use.
Remove the battery and store it in a safe, dry place if the device will not be used for a long
-
period of time.
To replace the battery, follow the instructions below:
1. Unscrew the 2 screws on the battery slot, remove the battery cover and the battery. Fig. 28
2. Insert the new battery with the battery label facing up. Fig. 29
3. Place the battery and the battery cover in its place and fix properly the screws back again.
6. TROUBLESHOOTING
Robot vacuum cleaner
warning
Steady 1 beep
red light
2 beeps
3 beeps
4 beeps
Cause Solution
Omnidirectional Clean the omnidirectional wheel and press
wheel error. the Start/Pause button to restart the robot
vacuum cleaner.
Side brushes Clean the side brushes and press the Start/
error Pause button to restart the robot vacuum
cleaner.
Suction motor Remove the tank and empty it.
error Remove the robot filter and shake off the
dirt.
Main brush Remote and clean the main brush and press
error the Start/Pause button to restart the robot
vacuum cleaner.
ENGLISH
47