cecotec CONGA 2299 INERTIAL GENESIS Manual De Instrucciones página 54

ENGLISH
Recommendation
It is recommended to clean the side brushes once a week with the help of the self-cleaning
brush.
Sensors
- The robot vacuum cleaner has different types of sensors, for example, proximity sensors
that allow the robot to move around while detecting obstacles, or fall-detection sensors
that help the robot detect slopes or possible gaps/unevenness such as staircases. These
sensors are always in contact with dust particles, and therefore can deteriorate over time,
causing possible navigation errors.
- It is suggested to clean all the robot sensors with a dry and soft cloth after a maximum of
35 hours of operation or less.
Charging and replacing the battery
- To lengthen the battery shelf life, leave the robot vacuum cleaner to charge in the charging
base when not in use.
- Remove the battery and store it in a safe, dry place if the robot vacuum cleaner will not be
used for a long period of time.
To replace the battery, follow the instructions below. Fig. 11:
Unscrew the screws on the battery compartment, remove the battery cover, and the
1.
battery itself.
2. Insert the new battery with the battery label facing up.
Put the battery and the battery cover in back in place and properly fix the screws back
3.
again.
Charging base. Fig. 12
Use a clean, dry, soft cloth to wipe dust off the charging terminals of the base.
6. TROUBLESHOOTING
Beeps while the light is red:
Beeps Error
1 Driving-wheel
fault
2 Robot's side brush
error
54
CONGA 2299 INERTIAL GENESIS
Solution
Check if the driving wheel is blocked.
Check if the side brushes are blocked and clean them.