Connection Of Accessories; Safety Instructions For Connecting Accessories; Ethernet Communication; Cabling Requirements - Ingeteam INGEREV FUSION Street Manual De Instalacion Y Uso

Ingeteam

7. Connection of accessories

This chapter explains the process for wiring the standard and optional accessories to the unit.
Read carefully before starting the connection process.

7.1. Safety instructions for connecting accessories

DANGER
Make sure there is no voltage present on the unit before starting the connection.
Do not switch on the power to the unit until you have successfully made the rest of the connections and the unit
is closed.
Use the Personal Protective Equipment specified in section "Personal Protective Equipment (PPE)".
CAUTION
Ingeteam accepts no liability for any damages caused by an incorrect connection.

7.2. Ethernet communication

7.2.1. Cabling requirements

For Ethernet communication, use a cable with a diameter of 4 to 6 mm.

7.2.2. Connection process

To make the connection, follow this order:
1. Introduce the Ethernet cabling through the corresponding gland in the lower cable access area.
2. Route the cabling through the side duct and connect to J17 or J18.
26 ABW2011IQM01_A - Installation and Operation Manual
Connection of accessories