MSW S-POWER UPS 800 PSW Manual De Instrucciones página 93

Main CPU version checking
OPERATING MODE DESCRIPTION
Mode
Standby mode/
Power saving
mode
Note:
Standby mode –
the inverter is
not turned on
yet but at this
time, the
inverter can
charge battery
without AC
output.
Power saving
mode – if
enabled, the
output of
inverter will be
off when
connected load
is pretty low or
not detected.
Fault mode
Note:
Fault mode –
errors caused by
inside circuit
error or external
reasons such as
over
Main CPU version 00014.04
Description
No output is
supplied by the
unit but it still
can charge
batteries.
PV energy and
utility can
charge
batteries.
EN
Displayed
Charging by utility and PV energy:
Charging by utility:
Charging by PV energy:
No charging:
Charging by utility and PV energy (only
available in - 1000VA/2000VA):
Charging by utility (only available in only
available in - 1000VA/2000VA):