Descargar Imprimir esta página

cecotec IRONHERO 2600 VITAL Manual De Instrucciones página 36

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 29
ENGLISH
position. Place the iron on a stand, tilt it forward at an angle of approximately 45 degrees and
pour water through the filler opening into the MAX position of the water tank.
Vertical steaming
The "steam burst" can also be applied when the iron is held vertically, which is useful for
removing wrinkles from hanging clothes, curtains, etc.
Dry ironing
1. Place the steam switch in the O position (that is, no steam.)
2. According to the care label of the different garments, set the correct ironing temperature
to start ironing.
Steam ironing
1. Fill the iron with water according to the water filling methods.
2. Plug the appliance into the main socket.
3. Set the temperature/thermostat selector to MAX position according to the temperature/
thermostat knob for steam ironing, otherwise water may come out of the soleplate.
4. When the indicator light goes out, it means that the right temperature for ironing has been
reached.
5. Set the steam switch correctly. To increase the steam, turn the switch counterclockwise
and to decrease the steam turn the switch clockwise.
Steam burst
This function is suitable for difficult creases and thick fabrics. When you press the "Steam
Burst" button, the soleplate emits an intense burst of steam, which is very useful for removing
stubborn creases. The steam function can only be used when ironing at a high ironing
temperature. For optimal results, there should be a 5 second rest period between pressing the
steam button. To avoid water leakage through the soleplate, do not press the steam button
continuously for more than 5 seconds. In addition, you should allow an interval of at least one
minute before using the steam burst function.
Spraying methods
By pressing the spraying button, a couple of times, garments can be dampened at any
temperature. Make sure there's enough water in the tank.
IMPORTANT
Self-cleaning
Use the self-cleaning function once every two weeks. If the water in your area is very
-
chalky (i.e. if flakes come out of the soleplate during ironing), you should use the self-
36
IRONHERO 2600 VITAL

Publicidad

loading

Este manual también es adecuado para:

01870