Zipper ZI-STE2800 Instrucciones De Servicio página 38

Ensure that the ON-OFF switch is turned to position "OFF".
•
After operation, allow the machine to cool down for at least 15 minutes.
•
Transport of the machine in a vehicle:
Check that no fuel can leak from the tank. Ensure that the fuel filler cap is tightly closed.
•
• When transporting the machine in a vehicle, ensure that the machine is appropriately secured!
The machine must be carried and transported in an upright position to avoid oil or fuel leak-
age.
If the machine is in a vehicle, do not start the engine. Take the machine out of the vehicle and
•
run it outdoors only.
Protect the machine from excessive heat during transport. If the machine remains in a closed
•
vehicle for a long time, the fuel may ignite due to overheating.
14 ASSEMBLY
14.1 Preparation
14.1.1 Checking delivery content
Check the delivery immediately for transport damage and missing parts. Report any damage or miss-
ing parts to your dealer or the shipping company immediately. Visible transport damage must also be
noted immediately on the delivery note in accordance with the provisions of the warranty, otherwise
the goods are deemed to have been properly accepted.
14.1.2 Requirements for the installation site
Place the machine on a level, solid surface to prevent the machine from tipping over.
When dimensioning the required space, take into account that the operation must be possible without
restrictions at all times.
14.2 Assembly
14.2.1 ZI-STE2800
ZIPPER MASCHINEN GmbH www.zipper-maschinen.at
1. Assembly wheels
Install the axis (1) in the holes provided for this
•
purpose on the machine.
Place a wheel (2) with a washer (4) on the axis
•
(1) and fix it with a cotter pin (3).
2. Assembly handle
Install the handle mounting (1) on the frame
•
with two bolts (2) and nuts (3).
Install the handle (4) to the handle mounting (1)
•
with a bolt (2) and nut (3).
Assemble the handle holder (5) with a bolt (6)
•
and nut (7).
3. Assembly rubber feet
Attach the rubber feet (1) to the frame with two
•
bolts (2) and nuts (3) each.
ZI-STE2800 / ZI-STE5500 / ZI-STE8000 / ZI-STE8004
ASSEMBLY
38