Zipper ZI-STE2800 Instrucciones De Servicio página 44

16 CLEANING, MAINTENANCE, STORAGE, DISPOSAL
Always stop the machine and let it cool down before carrying out any maintenance work
WARNING:
Lack of maintenance or improper maintenance and repair before using the machine can result in serious
injury or death! Take therefore the safety rules, operating and maintenance instructions very seriously. Re-
pairs only by qualified staff!
NOTE:
Prevent unintentional commissioning of the machine by interrupting the fuel supply (ON-OFF
switch in position "OFF"), disconnecting the battery (for ZI-STE8000 and ZI-STE8004) as well as interrupting
the ignition spark (remove spark plug cap of spark plug).
16.1 Cleaning
Regular cleaning guarantees the long service life of your machine and is a prerequisite for its safe operation.
NOTE: Incorrect cleaning products can attack the finish of the machine. Do not use any solvents, nitro thin-
ners or other cleaning products that could damage the machine's finish.
Thus, when cleaning, use only water and, if necessary, mild detergents.
We recommend cleaning the machine immediately after each use.
•
• Keep all safety devices, air vents and the motor housing free of dirt and dust as far as possible.
• Wipe the equipment with a moist cloth and some soft soap or blow it with compressed air at
low pressure.
• Take care that any water enters the interior of the machine.
16.2 Maintenance
The machine is low-maintenance and only a few parts need to be serviced. Malfunctions or defects that
could affect your safety must be repaired immediately!
Before each operation, check the perfect condition of the safety devices.
•
Regularly check the perfect and legible condition of the warning and safety labels of the ma-
•
chine.
Use only proper and suitable tools.
•
Use only original spare parts recommended
•
16.2.1 Maintenance plan
The type and degree of machine wear depends to a large extent on the operating conditions. The following
intervals apply when the machine is used within the technical limits:
(1) Interval can vary according to the air
quality
(2) Only by specialists!
Engine oil
Air filter
Spark plug
Valve clearance
Battery (for ZI-STE8000
and ZI-STE8004)
Fuel tank and fuel filter
Fuel pipe
ZIPPER MASCHINEN GmbH www.zipper-maschinen.at
WAR N I N G
and secure it against unintentional commissioning.
Prior to
each start
Control the
X
level
Change
Control X
Change
Control
Change
Control, ad-
justment
Charging (if
the machine
is stored for
a longer pe-
riod of time)
Clean
Control
CLEANING, MAINTENANCE, STORAGE, DISPOSAL
by the manufacturer.
(for new Every 3
machine) months
after first or every
Month or 50 opera-
20 opera- tion
tion hours hours
X
X (1)
O (monthly)
Yearly (2)
Every 2 years (2)
ZI-STE2800 / ZI-STE5500 / ZI-STE8000 / ZI-STE8004
Every 6 Every 2
months years or
or every every 300
100 oper- operation
ation hours
hours
X
X
X
X(2)
44